Today we are installing Fender Flares on my 1975 Ford Bronco.
These are the flares I got: https://tomsoffroad.com/parts/66-77-ford-bronco-ultraflex-fender-flares
These flares are made of ultra strong yet flexible urethane material, these Classic Bronco Fender Flares bend but don't break. Of all the flares I’ve seen, I like how these look on the Bronco the most.
Here's how to install the new Fenders:
00:00 - Introduction
01:49 - Prep new fenders
03:36 - Remove old fenders
04:53 - Paint new fenders
06:20 - Mock the new fenders up. This is the most important part. Make sure they look right from every angle. Make sure they are the same on both sides. I used a grease pen to mark where they were, then measure 1 inch down and made my line to cut.
07:07 - Cut the sheet metal
07:23 - Install the new fenders.
It really is an easy job, but it’s scary cutting up your Bronco!!
What do you prefer, cut or uncut?!?
The paint I used:
https://www.eastwood.com/ew-plastic-resurfacer-matte-black-aerosol.html
Hands on Cars Facebook: https://www.facebook.com/handsoncarskt/
Thanks for watching and be sure to SUBSCRIBE so you'll have more Early Bronco video's in your inbox! 📬
👕 10% Off Shirts! Use promo code: YOUTUBE http://bit.ly/NashEB 👕
🛠 Here are some of my favorite tools 🛠
https://www.amazon.com/shop/nashvilleearlybronco
👉🏼 My steering wheel 👉🏼 https://amzn.to/2NNX4on
➡️ http://www.nashvilleearlybronco.com ⬅️
🎥 SUBSCRIBE: http://bit.ly/2l5gZA0
📷 INSTAGRAM: http://bit.ly/NEBInstagram
💻 FACEBOOK: http://bit.ly/NEBroncoFacebook
#earlybronco #classicbronco #fordbronco
