Home » Science & Technology » DVT40GigaProbes DVT-FP60 Installation video (view 1st)

DVT40GigaProbes DVT-FP60 Installation video (view 1st)

Written By gigaprobes on Wednesday, Mar 29, 2017 | 11:32 PM

 
If you have purchased DVT40 GigaProbes with a Manipulator and a ground collar or a full two differential DVT40 GigaProbes® desk top probing setup this is the 1st video you should watch. It shows how to perform the following procedures on using only one probe that will assure a successful probing experience: 1) How to properly connect the DVT40 to the Probe positioners so not to damage the ground pins 2) How to detect if the probe tips are making contact with all the test pads 3) How to Planarize Both Probe Tips to make Accurate Measurements on all VNA or TDR Ports 4) How to replace a damaged Pogo-pin and to take off and put on the ground collar a. Demonstrates both type of Ground collars for SG probing of in line (L collar) and when ground is behind the test pads (H collar) using only one DVT40 GigaProbes. 5) Tips on how to make repeatable measurements and to protect probe from damage 6) For more information visit: www.gigaprobes.com Email: [email protected]